How to install a Pop Filter onto the BLUE Yeti MIC

Coming with no instructions The Pop by Blue Microphones wasn't the easiest install to work out but I've created a guide that allows you to install onto the Blue Yeti, with no drilling required.

My POP Filter of choice was THE POP by BLUE Microphones

My POP Filter of choice was THE POP by BLUE Microphones

There aren't any instructions but what you are looking to do is line up as in the above image (this screw is the one with the rubber point at the end).  Don't over tighten just yet, see the next image.

There aren't any instructions but what you are looking to do is line up as in the above image (this screw is the one with the rubber point at the end).  Don't over tighten just yet, see the next image.

You need to line up the vertical roughly in the middle of the MIC, I found lining them up with the controls to be the easiest way to do this.  Once you are happy with the alignment tighten off the screw

You need to line up the vertical roughly in the middle of the MIC, I found lining them up with the controls to be the easiest way to do this.  Once you are happy with the alignment tighten off the screw

Now the stand is in place you will need to move the flexible arm down to the lower position hole, this is so that you can curve it around in front of the MIC

Now the stand is in place you will need to move the flexible arm down to the lower position hole, this is so that you can curve it around in front of the MIC

It's done! not an obvious install but hope these instructions saved you some time

It's done! not an obvious install but hope these instructions saved you some time